Products  /  Truck solutions  /  TruckController

TruckController

Diagnostics unit for the J1939 CAN bus of trucks

TruckController is a diagnosis unit for truck and body manufacturers at the body builder CAN interface respectively FMS interface of trucks. It supports all prevalent messages according to SAEJ1939 standard.

Last time buy: 30.09.2020

    • CAN messages sent by the vehicle are evaluated and clearly visualized by the TruckController. Therefore it is easily and rapidly controllable, which values at the CAN bus are effectively active and ready to be utilized.

      Furthermore it is possible to send supported CAN messages from TruckController to the body builder CAN interface and consequently simulate a body builder ECU.

      CAN messages supported by the ECU are clearly visualized. In addition various parameters, like e.g. auxiliary drive (switch on/off), engine (start/stop) can be manipulated through the graphical user interface (GUI).

    • Depending on the vehicle type, following functions are supported

      • Dashboard: Visualization of common vehicle Parameters (F1)
      • Temperature, pressure and operating data: Visualization of temperature, pressure values and operating data, like hours of operation, fuel consumption etc. (F2)
      • Vehicle control: Manipulation of the engine as well as the PTO´s (F3)
      • Transmit messages: Transmit of all supported messages of the body builder CAN to the vehicle-CAN-Gateway (F4)
      • Receive messages: Visualization of all messages of the body builder CAN respectively FMS interface (F5)

    • Hardware specification - Hardware basis ifm display PDM_NG

      • Protocol: SAE J1939 - ISO 11898 – High-Speed-CAN / 5V Basis / 250kBaud
      • Dimensions (WxHxD): 192 x 157 x 64,5 mm
      • Display: TFT LCD - 7‘‘- 800 x 480 Px - 153,4 x 92,4 mm
      • Protection classification: IP67
      • Operating temperature: -30... +65°C
      • Storage temperature: -30... +80°C
      • Operating voltage: 10...32 V DC
      • Power input: 300 mA (bei 24 V DC)

    • Supported truck types - Type specific

      TypeInterfaceECU
      Mercedes-BenzBB-CAN / CoTel telematicsPSM 3 / EM9; PSM 4
      MANBB-CAN / FMS interfaceKSM
      ScaniaExternal CAN busBWS (Body Work System); BCI (Bodywork Communication Interface)
      VolvoBB-CANBBM (Body Builder Module)
      DAFBB-CANBBM (Body Builder Module)
      RenaultBB-CANBBM (Body Builder Module)
      IvecoCAN busVDI (Vehicle Data Interface), EM (Expansion Module)

       

      Supported truck types - Manufacturer independent

      TypeInterfaceECU
      FMSFMS standardFleet management system
    • NameBestellnummerBeschreibung
      TruckController NGB12000-TCC-001-1083TruckController – Diagnosis unit based upon ifm display
      CANPowerSupplyB12090-CPS-002-0500M12 cable socket straight, 500 cm 4pole CAN-cord with 120 Ohm resistor (further lengths available)

Information request

Infoanfrage

Inforequest

The use or processing of your data takes place within the framework of our data protection information, which you can view here.

* Mandatory item